Powerwalker Battery Pack for VFI 10000R LCD Manual do Utilizador descarregar pdf (Página 25)

Operating mode/status

Battery mode Description When the input voltage is beyond the acceptable range or power failure, UPS

will backup power from battery and alarm will beep every 4 seconds.

LCD display

Bypass mode Description When input voltage is within acceptable range and bypass is enabled, turn off

the UPS and it will enter Bypass mode. Alarm beeps every two minutes.

LCD display

Battery Test Description When UPS is in AC mode or CVCF mode, press “Test” key for more than 0.5s.

Then the UPS will beep once and start “Battery Test”. The line between I/P

and Inversor icons will blink to remind users. This operation is used to check

the battery status.

LCD display

Fault status Description When UPS has fault happened, it will display fault messages in LCD panel.

LCD display

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 89 90

Sem comentários

Powerwalker Battery Pack for VFI 10000R LCD Manual do Utilizador Página 25