Powerwalker Remote Panel Manual do Utilizador

TABLE OF CONTENTS 1. INTRODUCTION ················································································ １１１１ 2. FEATURES ··················

９11 Bypass mode ↑↑↑↑ ↑↑↑↑ ↑↑↑↑ ↑↑↑↑ ● ● ● Beep once every 2 min, ◇ 12 Overloaded in Line mode ● ● ● ● ● ● ● ● B

１０22 BAT SCR failed ● ● ● ↑↑↑↑ ↑↑↑↑ Continuously beep, ◇ 23 Fan abnormal ● ● ● ↑↑↑↑ ↑↑↑↑ ↑↑↑↑ ↑↑↑↑ Beep once every se

１１◇ : Alarm can be muted by pressing Mute button. ◆ : Alarm can’t be muted by pressing Mute button. 4.3 EPO Operation EPO Trigger: In emerg

１1. Introduction The Remote Panel is a connectivity device that allows you to remotely monitor the status of the UPS. The Remote Panel include three

２ Panel Interface LED Version Side view

３Power LED: Red LED, when the Power LED is turned on, it shows the power of the remote panel is OK. Signal LED: Green LED, when the Signal LED is fla

４2. Features The Remote Panel has the following features: ● Real-time monitoring the UPS conditions. ● Can be located away from the UPS with a straig

５3. Installation Please follow the following steps to install the Remote Panel to the UPS: 1. Insert the Remote Card into the intelligent slot of the

６5. If you want hang the Panel Interface to the wall, please fix two nails with width 9 cm on the wall. Since there are two holes on the backside

７4. Panel information and operation 4.1 Panel information 4.1.1 LED Display Panel ● Mute: Short－press(>0.5s, <4.5s)to mute or activate.

８● #2~#6 LEDs: The #2 LED is orange and the #3~#6 LEDs are green, these LEDs indicate the percentage of the load level in Line mode and Bypass mode,