Powerwalker Battery pack for VFI 10000P_RT LCD Manual do Utilizador descarregar pdf (Página 28)

4.4 Frequency converter connection

Figure 4-4. Frequency converter connection

4.5 UPS Initial Startup

To start up the UPS:

Verify that the total equipment ratings do not exceed the UPS

capacity to prevent an overload alarm.

1. Verify that the internal batterties are connected.

2. If optional EBMs are installed, verify that the EBMs are

connected to the UPS.

3. Set the upstream circuit breaker (not included) to the “I” position

(ON).

The UPS display panel illuminates and shows a status of

“Welcome”

4. Verify that the UPS transfers to Bypass mode.

5. Press the button on the UPS front panel for at least three

seconds.

The UPS display “

” with flashing.

6. Check the UPS display for active alarms or notices. Resolve any

active alarms before continuing. See “Troubleshooting”

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 63 64

Sem comentários

Powerwalker Battery pack for VFI 10000P_RT LCD Manual do Utilizador Página 28